Peugeot 308 Key Fob Replacement
Peugeot's 308 may be slightly old, but it is still appealing. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.
We often receive requests from Coded Car Keys to replace peugeot key fobs. Whether the problem is intermittent or constant, the following tips should aid.
Water Damage
If you accidentally drop your key fob into the puddle, or it is wet while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. The best way to prevent this from happening is to keep it in a dry container when you're outdoors or performing activities that require the fob to be exposed to large amounts of water.
It's also crucial to make sure the fob has completely dried out prior to opening it to use it again. If you notice any odors emanating from the fob such as an industrial-type liquid smell or that of windshield washer fluid, this is another indication that it's submerged in water.
A circuit board that's wet can cause the battery to discharge its charge, or even explode. If you are able to get your keyfob 308 out of the water and turn it upside up and shake as much water as you can prior to opening the casing. When you've opened it, take off the battery and wipe the circuit board with the help of a cotton swab that has been dipped in 90 percent isopropyl alcohol.
peugeot 207 car key why your Peugeot 308 remote keyless entry system might stop working include an empty coin battery or receiver module issues signal interference, an electronic chip malfunctioning. If none of the above are the issue you can restart the system by disconnecting 12 voltage battery from the car for 15 mins.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows the driver to start the car from a distance and then warm up or cool down the car prior to entering. This feature is extremely beneficial especially during the cold winter months. But sometimes, the remote stop system stops operating due to a range of reasons, like a dead coin battery.
A coin-shaped battery that is located inside the key fob has a life span of two to four years, based on how often it is used and where it's purchased. Its use-by date is typically printed on the package or written in the manual.
If the key fob stops working after exposure to clean tap water, you should remove the battery, clean the chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. In the event of exposure to salty or soapy water, the chip might be damaged and you'll have to replace the key fob altogether.
If you're unsure if the battery is defective it is possible to check the voltage using a multimeter connected to both the plus and minus terminals. The voltage should read approximately 12 to 13 volts, but if it is lower, the battery should be replaced. Alternately, you could try to reset the on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should now start.
Faulty Receiver Module
If you don't see "Key Detected" It could be that your receiver module is malfunctioning. It's the component that sends a signal to the car when the key fob is activated, which also acts as an immobiliser. It stops it from starting until the key that you want to use is present.
This could be due to a variety of causes including water damage or simply getting old. If your Peugeot 308 key fob has been exposed to dirty tap water, for example, the electronic chip on the inside will be damaged. In this situation, you'll need to take it out and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry, you can put the battery back into the battery and try again.
If the issue persists, it is recommended that you visit an area Peugeot expert or locksmith. They'll employ a diagnostic tool identify the problem and repair it for you.
It can be stressful to lose your Peugeot car key. A reputable auto locksmith can solve the problem within minutes. They can program your car and cut a fresh, working key for you. Click here to find a local locksmith near you.
Faulty Electronic Chip
The chip inside the Peugeot 308 key fob is a very vital component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message that says "anti-theft". In this situation the only option is to replace the key. Luckily, auto locksmiths who are professionals are able to provide this service in the shortest amount of time.
The chip in the key fob of your Peugeot 308 may become faulty for many reasons, such as sweat, water damage or dirt. If your Peugeot key fob has been exposed to soapy or dirty water, it must be cleaned as soon as possible. You can make use of a paper towel and isopropyl ethanol to clean the electronic component. The battery should be allowed to completely dry.
Sometimes keys can not function due to radio interference. This could be caused by other devices operating on the same frequency as your Peugeot key fob. It can also be caused by bad weather or objects in the vicinity of the vehicle. If you experience this problem you should visit the Peugeot dealership.
The Peugeot 207/308 key fob is very delicate and requires care. It is essential not to drop or throw the key fob. If you lose it, try to find it as quickly as is possible. You can reset the on-board computer by disconnecting the battery for a couple of minutes. Be sure to disconnect the negative cable first, then the positive.